Premier Electrician in Minneapolis, MN

Inspected boiler system with reported intermittent zone control issue. Observed Tekmar 260 control panel functioning normally, showing proper temperature readings. Examined zone valves and associated piping; system was operating correctly during service visit with all zones responding properly to thermostat commands. No intervention required as all components were functioning within parameters at time of inspection.

Completed preventative maintenance on Fall PA system including service of 2 in-floor heat boilers, 1 furnace, 1 humidifier, and 1 gas fireplace. All systems inspected and verified operational with appropriate pressure and temperature readings. No issues identified during maintenance.

Diagnosed furnace failure caused by faulty igniter as confirmed with digital clamp meter testing. Removed access panel, replaced defective igniter component, and verified proper ignition sequence and system operation before completing service.

Responded to service call for recurring condensate pump leak. Upon inspection, found damaged condensate pump with broken component on rear section, showing evidence of water damage to surrounding baseboard. Replaced faulty condensate pump to resolve the persistent leakage issue.

Responded to emergency call for overheating boiler system affecting multiple zones. Diagnosed faulty Taco zone control board preventing proper zone closure. Replaced control board and verified proper operation of NTI boiler system with temperature now regulated at 69°F. All zones now functioning correctly with no overheating issues.

Completed routine heating maintenance on customer's system which includes a boiler, HRV, gas fireplace, and Aprilaire 600 Series humidifier. Inspected all components for proper operation and replaced the humidifier filter pad as part of the scheduled service. Customer was not present during visit; left voicemail and text message to reschedule remaining portions of maintenance.

Diagnosed temperature inconsistency in dual-zone system caused by loss of power to zone dampers. Replaced failed Honeywell zone controller module to restore proper functionality to 10-year-old furnace system.

Performed maintenance service on two gas fireplaces, including cleaning and comprehensive tune-ups. For the malfunctioning unit that would light but extinguish after several minutes (while maintaining pilot light), diagnosed structural issues including wall cracking and deterioration near the fireplace. Completed necessary repairs to resolve the intermittent flame issue while ensuring all three units are functioning safely and efficiently.

Performed annual boiler maintenance and tune-up service. Inspected burner assembly and heat exchanger components, confirming proper operation and structural integrity. All connections and wiring were verified to be secure and in good working condition.

Completed prepaid maintenance visit on Triangle Tube boiler system and gas fireplace. System inspection found boiler operating normally with proper temperature settings and pressure levels. Customer reported potential water damage in kitchen after bleeding upstairs radiator; company will follow up regarding possible water line issue.

Inspected ductwork system and identified multiple dampers not functioning properly due to missing control levers. Accessed system via customer-provided ladder, assessed mechanical condition, and found some dampers potentially stripped. Installed new damper control levers to restore proper airflow regulation throughout the ducting system.

Performed routine furnace maintenance including comprehensive system tune-up. Inspected circuit board and electrical connections for proper operation. Serviced Breathclean air purification system (Model #7200, S/N 202103757), replacing UV light bulb and filter as scheduled maintenance requirement.

Performed scheduled Fall tune-up service on Bryant HVAC system, including inspection of furnace and humidifier plumbing. Conducted comprehensive diagnostic testing with Testo analyzer, confirming system is operating within normal parameters. All components verified to be in good working condition with no issues requiring attention.

Performed scheduled heating tune-up on customer's system, including inspection and maintenance of one furnace and Aprilaire Model #600A whole-home humidifier. Inspected air filtration system, noting some dust accumulation on the filter mesh. All components functioning properly after service.

Completed prepaid maintenance visit on home heating system, including inspection and testing of furnace, humidifier, and gas fireplace. Performed full system diagnostic with Testo 310 analyzer and inspected internal electrical components, blower motor, and control board. All systems functioning properly with no issues identified.

Performed routine maintenance on Prestige residential boiler system and Carrier outdoor AC unit. Inspected all copper piping, valves, expansion tank and connections, ensuring proper operation of the heating system as requested. Cleared debris from around outdoor condensing unit and visually inspected for any external damage or issues.

Performed comprehensive tune-up maintenance on two heat pump systems. Inspected outdoor condenser units, cleaned components, verified proper operation, and checked refrigerant lines. Both systems are now functioning efficiently with no operational issues identified.

Completed scheduled Fall heating maintenance on property's multiple HVAC systems, including 1 furnace, 1 humidifier, 1 boiler for in-floor heating, and 2 GFPs. Inspected TriangleTube boiler control panel and blower assembly components, confirming proper operation of all systems. Also performed requested dryer vent cleaning as additional service.